Active boot disk serveraid drivers11/29/2023 ![]() Deleting an array confirmation in the UEFI BIOS.The Boot Disk cannot see the drives in my system, what can I do so they would be detected? When the delete option is selected, you must confirm the array deletion, and you receive a warning that the Volume is being wiped. If an array already exists, there is an option available to delete the array. Once the Array is complete, you can see the status of the array.Creation of the Volume after drive selection is completed. Use the arrow keys to go to the " Create Volume" option that becomes available once there are at least two drives selected.Selection of the second drive for the array. Repeat the selection process for the second, third, or even fourth drive (Depending on drive and chassis configuration) (See Figure 16.)įigure 16.An on-screen box appears for the drive, use the arrow key to highlight the selection space, type an "X" to select then press the " Enter" key to complete the drive selection.Selecting the first drive to add to the array. Use the arrow keys to highlight the drive, then press the " Enter" key to select the drive to add. Once you have selected your array type, you then must select the drives to be configured in the array. ![]() Changing from the default RAID 1 to RAID 0 striped array. ![]() In this configuration, we change from the Default RAID 1(Mirror) to the RAID 0(Stripe) option using the " +" Key.To create a RAID array, ensure " Create RAID Volume" is highlighted (using the array keys) then press the " Enter" key to start the array creation process. Once you select Device Configuration and press the " Enter" key, you are presented with the RAID status page.You can also create RAID volumes in the UEFI RAID BIOS that you access from the F12 Device configuration menu (See Figure 6 above.) RAID 1 volume creation is complete.Ĭreation of a RAID Array in the UEFI BIOS Selection of the size of the RAID 1 array. There is an optional selection of the size of the RAID 1 array (Default is 100%).Select the drives to create the RAID array.Creating a RAID 1 Array (Mirror) using the Intel Integrated RAID controller and the Intel Rapid Storage Technology user interface.UEFI Pre-Boot Menu, Device Configuration optionĬreation of a RAID 1 (Mirror) in the IRST User Interface Then, select " Device Configuration" from the list shown in the F12 preboot menu. Press F12 on power up while at the Dell logo splash screen. When these computers are configured in UEFI BIOS mode, the RAID setup is accessed from the F12 preboot menu. NOTE: After the array is created, you are prompted to open Disk Management to create and format partitions on the array. Recovery Volume array creation completes. Click OK on the volume creation complete.Confirm the creation of the recovery volume.Selection of the disk assignments in the Recovery array. Configure the selected drives in the RAID array.Select the type of RAID array that you want to create.The first step in creating a Recovery RAID Array Creating a Recovery Array (Default) using the Intel Integrated RAID controller and the Intel Rapid Storage Technology user interface.The IRST user interface allows you to create RAID array configurations from within the operating system with ease. Other RAID controllers may have different screens, but the basic configuration functionality should be similar. ![]() Intel Integrated RAID can be configured from either the Intel Rapid Storage Technology (IRST) user interface or from the RAID BIOS.īelow are examples of the IRST User Interface (UI) and the UEFI BIOS during the configuration of Intel Integrated RAID. See Figures 2-19 for examples of the Intel Integrated RAID in UEFI mode. The RAID setup utility runs and allows for configuration of the computer’s RAID array. Creation of a Recovery Array in the IRST User Interface
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |